PICOUP400 Remote controlled hydraulic spiking and cutting tool

STANDARD(S) : According to NFC 18510
USE :
- SPIKING cable to check and ensure the absence of voltage on LV and MV underground cables before cutting them
LV cable up to 3 x 500 mm² with reinforced steel wire.
MV cable up to 3 x 500 mm² with reinforced steel wire
Enabes the user to limit any resulting short circuit to a single-phase / ground fault when spiking multi core cables. This causes any protective devices tot rip before a 2 or 3 phase fault can be created.
- CUTTING after spiking operation in full safety

SPECIFICATIONS :
• Cutting head
- A dual-stage hydraulic ram
- Flexible, copper earthing cable of 2 meters long
- Cutting blades made of reinforced, heat-treated steel specifically engineered to cut cable
- MAX CUTTING CAPACITY : up to 140 mm outer diameter
- Can cut armored cable : up to 4mm round steel wire
- Maximum section : 3 x 500 mm2
- Cutting force : 21 000 kg
- Nominal pressure : 700 bars
- Dimensions L x W x H : 678 x 188 x 320 mm
- Weight : 20 kg

• Control box
Light for checking battery checking
• Remote control (868 MHz)
- Used up to 150 meters
- indication of cutting state

• Power
- Voltage : 24V 3Ah
- Battery level with LED indication
- 20 Cuts capacity

• Full set
- Delivered in foam filled plastic box with trolley
- Flexible copper cable and earthing rod
- 2 batteries
- Fast charger
- Key dismantling blades
- 1 cleaning brush
- 1 replacement spiking and cutting blades
- Flash protective mat 0.7 m x 1m
- External dimensions L x W x H : 687 x 528 x 376 mm
- Total weight : 40kg

ADVANTAGES :
- Operating from a minimum distance of 8 meters, protecting the operator in the event of a live cable being spiked
-Damage to infrastructure is minimised when spiking as a single phase to earth fault is created using a dedicated, local 70mm² copper earthing cable.
- Compact design, robust and easy to use
- More security for the user : Indicator LEDs during the spiking and cutting operation
- Cutting failure sensor
- Blade closure sensor
- Hydraulic over pressure valve
- Checking of cutting time
- Electronic locking of the tool when battery runs low